Table of Contents
Advertisement
1
2
1. Fill port
2. Dipstick
4. Unscrew the dipstick and wipe the end clean (Figure 9).
5. Slide the dipstick fully into the fill port (Figure 9)
without threading it into the port.
6. Remove the dipstick and look at the end. If the engine
oil level is low, slowly pour only enough oil into the fill
port to raise the level to the Full mark on the dipstick
(Figure 9).
7. Install and secure the dipstick.
Checking the Gearcase Oil
Level
Service Interval: Before each use or daily
1. Stop the machine on a level surface.
2. Set the Dyna-Clutch lever to the Stop position, stop
the engine, and wait for all moving parts to stop.
3. Look at the sight glass in the gearcase plug (Figure 10).
The oil level should be 3/4 full .
3
4
Figure 9
3. Oil-level upper limit
4. Oil-level lower limit
G019746
If the oil level is not correct, refer to Servicing the Gearcase
Oil (page 16).
Cleaning Debris from the
Machine
Service Interval: Before each use or daily
1. Set the Dyna-Clutch lever to the Stop position, stop
the engine, wait for all moving parts to stop, and turn
off the engine switch.
2. Brush dirt and debris away from the air cleaner and
engine openings.
Folding and Unfolding the
Handle
1. Turn the handle-adjustment knob counterclockwise
to loosen the handle.
2. Place the handle to the desired position and turn
the handle-adjustment knob clockwise to tighten the
handle (Figure 11).
9
g021590
Figure 10
Advertisement
Table of Contents
