Table of Contents
Advertisement
Engine Cooling Fan Switch
The machine is equipped with a hydraulically driven
auto reversing engine cooling fan. The fan switch
(Figure 5) has two positions R (manual reverse) and
Auto (normal). Refer to Engine Cooling Fan Operation
in the Operation Section of manual.
1
2
3
1. Power point
2. Engine cooling fan switch
Hour Meter
The hour meter (Figure 5) shows the total hours that the
machine has been operated.
Power Point
The power point (Figure 5) is used to power optional
electrical accessories.
Audible Alarm
To warn bystanders, an alarm will sound if the cutting
decks are lowered with the engine off. The alarm will
quit sounding once the deck lower switch is released.
Also, the alarm will sound if the engine coolant
temperature reaches a set-point that cuts out the PTO
operation. The alarm will continue to sound until the
coolant temperature drops below the set-point or the
PTO switch is disengaged.
Cab Controls
Model 30446 only
Wind Shield Wiper Switch
Press front of switch to activate the wind shield wipers
(Figure 6) and rear of switch to turn off the wipers.
G011547
Figure 5
3. Hour meter
Air Conditioning Switch
Press front of switch to activate the air conditioning
(Figure 6) and rear of switch to turn off the air
conditioning.
Fan Control
Rotate the fan control knob to regulate the speed of the
fan (Figure 6).
Temperature Control
Rotate the temperature control knob to regulate the air
temperature in the cab (Figure 6).
1. Wind shield wiper switch
2. Air conditioning switch
Wind Shield Latch
Lift up on latches to open the wind shield (Figure 7).
Press in on latch to lock wind shield in open position.
Pull out and down on latch to close and secure wind
shield.
17
Figure 6
3. Fan control
4. Temperature control
Advertisement
Table of Contents
