Loose Parts; Unfolding The Handle - Toro 38516 Operator's Manual

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Step
1.
2.

1. Unfolding the Handle

1. Cut the plastic tie that secures the control cable to the
handle.
Note: Hold the cable taut to ensure that it stays
connected at the bottom.
2. Loosen the knobs, pull out the handle bolts, and rotate
the upper handle to the operating position (Figure 3).
Reorder part no. 105-3523
Description
No parts required
Discharge chute
Chute handle
Phillips head screws
Washers
Locknuts
105-1981
Qty.
–
Unfold the handle.
1
1
3 Install the discharge chute.
3
3
5
Use