Fuel Tank; Troubleshooting; Specifications - Toro ProLine 53030 Operator's Manual

5. Remove the spark plug and squirt a very small
amount of oil into the cylinder.
POTENTIAL HAZARD
Oil may squirt out of the spark plug
opening when you pull the starter handle.
WHAT CAN HAPPEN
Oil can cause eye injuries.
HOW TO AVOID THE HAZARD
Protect your eyes and keep your face away
from the spark plug opening.

Troubleshooting

Problem
Engine Will Not Start
Engine Will Not Idle
Engine Lacks Power or Stalls When
Cutting Cutting
If further assistance is required, contact your local authorized Toro service dealer.

Specifications

Engine Displacement
Shaft
Anti Vibration
Carburetor
Ignition System
Fuel Tank Capacity
Gas to Oil Ratio
Cause
STOP switch set to off position
Empty fuel tank
Primer bulb wasn't pushed enough
Engine flooded
Idle speed set incorrectly
Throttle wire has come loose
Dirty air filter
26cc
Curved full support
Dual Isolation – grip
and engine mount
Walbro – Choke Type
Solid State
0.85 qts. (0.8 liter)
50:1
6. Pull the starter handle once.
7. Slowly pull the starter handle to bring the piston
to the top of the cylinder (TDC).
8. Reinstall the spark plug.
9. Store the Edger in a dry place away from
excessive heat, sparks or open flame.
Move switch to on position
Fill fuel tank
Press primer bulb until fuel flows
through fuel return line
Use warm engine starting
procedure
Set idle speed
Tighten throttle wire
Clean or replace air filter
Blade Type
Weight
Spark Plug
Spark Plug Gap
CARB Approved
Safety Goggles
Included
Action
8" spring steel
15 lbs. (6.8 kg)
NGK BPM6Y
.024–.028 in
(0.6–0.7mm)
yes
yes
15