Maintenance; Recommended Maintenance Schedule - Toro Reelmaster 4000-D 03706 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule

Maintenance Service
Interval
After first 10 hours
After first 50 hours
Every 50 hours
Every 100 hours
Every 150 hours
Every 200 hours
Every 400 hours
Every 800 hours
Every 1600 hours or
every 2 years,
whichever occurs first
1
Service air cleaner whenever indicator shows red
Important
Refer to your engine operator's manual for additional maintenance procedures.
Maintenance Procedure
• Check the fan and alternator belt tension.
• Torque the wheel lug nuts.
• Change the engine oil and filter.
• Check the engine RPM (idle and full throttle).
• Change the hydraulic filter.
• Change the front planetary gear lube
• Lubricate all grease fittings.
1
• Check the air cleaner.
• Check the battery fluid level and cable connections.
• Lubricate reel control valve grease fitting
• Lubricate reel speed valve with oil
• Drain water from hydraulic tank
• Inspect the cooling system hoses.
• Check the fan and alternator belt tension.
• Change the engine oil and filter.
• Torque the wheel lug nuts.
• Inspect cutting unit reel drive belts
1
• Service the air cleaner.
• Replace the fuel filter.
• Check the engine RPM (idle and full throttle).
• Inspect fuel lines and connections
• Drain and clean fuel tank
• Change the hydraulic filter
• Change hydraulic tank breather
• Check rear wheel toe-in.
• Pack the 2WD rear wheel bearings.
• Change the front planetary gear lube
• Adjust valves
• Replace all moving hoses.
• Flush/replace the cooling system fluid.
• Drain/flush hydraulic tank.
26