Hour Meter; Transport Latches; Engine Preheat Indicator Light; Key Switch - Toro Reelmaster 4000-D 03706 Operator's Manual

Important Cam lever nut (Fig. 11, Inset) can be
tightened if limiter stop will not hold traction pedal in
desired position.

Transport Latches

Latches secure cutting units in upright position for transport
operation. Latch for front cutting units is foot–operated
(Fig. 11). Hand–operated latches control the center and
outside cutting units (Fig. 12).
1
2
Figure 12
1. Center cutting unit latch
Cutting Unit Lift Controls
The two outside levers (Fig. 13) raise and lower the two
outside cutting units. The center lever raises and lowers the
two front and the center cutting units. Engine must be
running to lower cutting units. When cutting units are
lifted, reels automatically stop. Do not allow levers to
snap–back to neutral, or cutting units may not float freely.
Engine Override Button
When button (Fig. 13) is depressed, engine can be operated
after it has over heated and automatically been stopped by
the electrical safety system. Use only for short intervals.

Fuel Level Gauge

Gauge (Fig. 13) indicates amount of fuel in tank.
2. Outside cutting unit latch
19

Hour Meter

Hour meter (Fig. 13) indicates total hours that machine has
been operated.
Note: Lines circling in the small window at left side of
gauge indicate hour meter is operating.

Engine Preheat Indicator Light

Light (Fig. 13) turns on when key is moved to ON position.
Glow plugs engage for 10 seconds, then, light goes off
when engine is ready to start.

Key Switch

Three positions: OFF, ON and START. Rotate key
(Fig. 13) to START and release key when engine begins
running. To stop engine, rotate key to OFF.
Parking Brake Lever
Pull lever (Fig. 13) up to lock brake. To release brake, pull
up on lever, press button and lower lever. Brake must be
engaged to start engine. Always engage parking brake
before getting off seat.
Mow–Backlap Lever
Move lever (Fig. 13) forward to engage cutting units. Move
lever to the center to stop the cutting units. To backlap
cutting units, lift lever over stop and hold in the rear
position.
Important
Do not move lever directly between MOW
and BACKLAP positions. Pause briefly in STOP position.
Reel Speed Control
Rotate knob (Fig. 13) clockwise to increase reel speed,
counter–clockwise to decrease speed. Use in conjunction
with the ground speed limiter to achieve appropriate rate of
clip.

Throttle Control

Move control (Fig. 13) forward to increase engine speed,
backward to decrease speed.
4 Wheel Drive Switch
Move switch (Fig. 13) forward to engage 4 wheel drive.
Move switch to rear position to disengage 4 wheel drive.
(4 wheel drive model only)