Table of Contents
Advertisement
4
Setup and
Adjustments
This owner's manual
covers various models
of lawnmowers. The
units illustrated may
vary slightly from your
unit. Follow only those
instructions which
pertain to your model
lawnmower.
IMPORTANT
This unit is shipped
WITHOUT GASOLINE
or OIL. After assem-
bly, service engine
with gasoline and
oil as instructed in
the separate engine
manual packed with
your unit.
A
B
Figure 4-1
A
Figure 4-2
B
C
Figure 4-3
NOTE: Reference to right, left, front and rear of the lawn
mower is in relation to the operating position.
1. Remove any packing material which may be
between upper and lower handles.
B
a.
Pull up and back on the upper handle to raise the
handle into the operating position. Position A.
b. Tighten knobs securing upper handle to lower
handle. Make sure that each carriage bolt is seated
properly in the handle. Position B.
2. Locate hairpin clip in one hole on the weld pin on each
side of lower handle.
a. Remove hairpin clip from this hole. Using a pair of
pliers, insert hairpin clip into the other hole on the
weld pin. Repeat on other side. Position A.
A
3. Rope guide Setup as follows, see Figure 4-3.
a. Hold the blade control against the upper handle.
Position A.
b. Slowly pull starter rope out of engine. Position B.
c. Slip starter rope into the rope guide. Position C.
d. Tighten rope guide wing nut
D.
D
8
WARNING: Disconnect and ground
the spark plug wire as instructed in the
separate engine manual.
Figure 4-2.
(star
knobs).Position
Advertisement
Table of Contents
