Yamaha Wolverine YX70EPNG Service Manual page 81

1. Wire harness
2. Headlight lead (right)
3. Load control relay
4. Differential motor relay 2
5. Fuel injection system relay
6. Differential motor relay 1
7. Radiator fan motor relay
8. Headlight relay
9. Main fuse lead
10. Fuel injection system fuse
11. Battery
12. EPS control unit (for EPS models)
13. EPS motor lead (for EPS models)
14. Headlight lead (left)
15. EPS torque sensor lead (for EPS models)
16. Lean angle sensor lead
17. Negative battery lead
18. Starter relay lead
19. Positive battery lead
20. EPS fuse (for EPS models)
21. ECU lead
22. Main fuse
23. Starter motor lead
24. Fuse box
A. Fasten the right headlight lead with the holder on
the electrical components tray.
B. Fasten the wire harness and main fuse lead with
the plastic band, making sure to align the band
with the white tape on the harness.
C. Fasten the left headlight lead, EPS motor lead (for
EPS models), and EPS torque sensor lead (for
EPS models) with the holder on the electrical
components tray.
D. Place the slack in the leads in the electrical
components tray.
E. Connect the EPS motor coupler and EPS torque
sensor coupler, and then insert the projection on
each coupler into the hole in the electrical
components tray. (For EPS models)
2-48
CABLE ROUTING