Replacement Of Lamp Bulbs - Mitsubishi Carisma Owner's Manual

FOR EMERGENCIES
5. Insert a new fuse of the same capacity
into the clip and insert the fuse at the
same place in the fuse box.
CAUTION
(1) If the newly inserted fuse blows
again after a short time, have the
electrical system checked and re-
paired by an authorized MITSUBI-
SHI dealer to find the cause and
rectify it.
(2) Never use a fuse with a capacity
larger than that specified or any
substitute, such as wire, foil, etc.;
doing so will cause the circuit wir-
ing to heat up and could cause
fire.
8–26

Replacement of lamp bulbs

Before replacing a bulb, ensure the lamp is
off. Do not touch the glass part of the new
bulb with your bare fingers; the skin oil left on
the glass will evaporate when the bulb gets
hot and the vapor will condense on the re-
flector and dim the surface.
N29C001a
EN10A-Ab
Bulb capacity
A bulb should only be replaced with a new
bulb of the same rating and type. The desig-
nation can be found on the base of the bulb.
Outside
1- Position lamps . . . . . . . . .
2- Headlamps, High/low beam
. . . . . . . . . . . . . . . . . . . .
3- Front turn - signal lamps
. . . . . . . . . . . . . . . . . .
4- Side turn - signal lamps
. . . . . . . . . . . . . . . . . . . .
5- Front fog lamps*
N10B296a
EN10BMDh
4W (T4W)
60/55W (H4)
21W (PY21W)
5W (WY5W)
. . . . . . . . 55W (H3)