Hitachi CP-WU5500 User Manual page 50

Operating
PbyP (Picture by Picture) / PinP (Picture in Picture) (continued)
 PbyP /PinP SWAP function
Press the MY BUTTON assigned the PbyP / PinP SWAP (84). The position of
the both area is exchanged without any setting change.
main sub
area area
NOTE
• For some signals, it may not be displayed correctly in the PbyP / PinP
mode, even if it can be displayed properly in the normal mode.
• PbyP/PinP is unavailable when MANUAL is selected in GEOMETRY
CORRECTION > EDGE BLENDING > MODE.
 Changing the size of main area in PbyP mode
Using ▲/▼ buttons on the remote control changes the size of main area in
PbyP mode.
main area
sub area
 Changing the position of sub area in PinP mode
1. Select INPUT MENU > PbyP / PinP SETUP > PinP POSITION (67).
2. Using ▲/▼ buttons on the remote control changes the position of sub area
in PinP mode.
main area
sub area
50
sub main
area area
PbyP mode
main area sub area
main area
sub area
main area
sub area
PinP mode
main area
main area
sub area
sub area
main area
sub area
main area
sub area