JVC KW-AVX706 Instructions Manual page 436

ELECTRICAL CONNECTIONS
Before connecting...
Check the wiring in the car carefully. Incorrect connection may cause serious damage to the units. The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Connect the wiring harness to the main unit.
Rear ground terminal
B
A C D
2
See below
To antenna
* 1 Not included with this unit.
* 2 Before checking the operation of this unit
prior to installation, this lead must be
connected, otherwise power cannot be
turned on.
White with black
stripe
Left speaker (front)
Connecting the parking brake wire
Crimp
Parking brake
Parking brake switch
(inside the car)
Connecting the AV I/O cord
B
2nd AUDIO OUT
L
R
VIDEO OUT
LINE IN
L
R
VIDEO IN
Audio/video cords
REVERSE
GEAR
(not supplied)
SIGNAL
Reverse gear signal extension
cord (Required only when connecting
a rear view camera to VIDEO IN plug.)
To car battery
Reverse lamp lead
Connecting the external components
D
CAUTION: Before connecting the external components, make sure that the unit is turned off.
®
CD changer, Apple iPod , or JVC D. player
Set the external input setting correctly—either "Changer," "iPod," or "D. player" (See page
42 of the INSTRUCTIONS.)
*5
* 5 Connecting cord supplied for your CD
changer
3
Fan
Black
Yellow* 2
Red
Blue
15 A fuse
Blue with white stripe
Orange with white stripe
Brown
Light green
9
Gray with black
White
stripe
Parking brake wire (light green)
PARKING
BRAKE
To metallic body or
chassis of the car
2nd monitor
(KV-MR9010, etc.)
L
R
Cordless headphones
(KS-HP2)
L
R
Playback source
(Video camera, etc.)
Reverse lamp
Crimp
REVERSE GEAR SIGNAL
To reverse lamp
*6
JVC CD changer
*5
6
* KS-PD100/KS-PD500 (separately
purchased)
1
1
To metallic body or chassis of the car
2
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch)
3
To an accessory terminal in the fuse block
4
To automatic antenna if any (250 mA max.)
5
To the remote lead of other equipment (200 mA max.)
6
(ILLUMINATION)
7
(PARKING BRAKE)
Green with black
Gray
stripe
Right speaker (front)
Connecting the external amplifiers
A
You can connect amplifiers to upgrade surround system in the car compartment.
• Connect the amplifiers to 5.1-ch analog discrete output jacks to enjoy multi-channel source
(DVD Video/DVD Audio).
• To activate the center speaker, see page 40 of the INSTRUCTIONS.
• Disconnect the speakers from the main unit, and connect them to the amplifier. Leave
the speaker leads of the unit unused.
Front
Amplifier
speakers
* 3
Rear
Amplifier
speakers
* 3
3
* Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place
uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure
to do so may cause damage to the unit.
Connecting the TV tuner
C
Diversity antennas
(supplied for KV-C1008)
* 4 Do not use these terminals.
Other external component
Select "External Input" for the external input setting (See page 42 of the INSTRUCTIONS.)
Line Input Adapter KS-U57
*6
(separately purchased)
Apple
iPod
JVC
D. player
*6
AUX Input Adapter KS-U58 (separately purchased)
To disconnect the connector
*6
• iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.
2
*1
*1
To car light control switch
To cellular phone system
To parking brake of the car (see below)
8
Crimp
Purple with black
Green
stripe
Left speaker (rear)
INPUT
L L
R
R
INPUT
L
L
R
R
L R R L
JVC TV tuner unit KV-C1008
*4
AV BUS cord (supplied for KV-C1008)
Audio cord
(not supplied)
Hold the connector top tightly (1),
then pull it out (2).
Ignition switch
Fuse block
Purple
Right speaker (rear)
Center
INPUT
Amplifier
speaker
* 3
INPUT
Subwoofer
Amplifier
* 3
External component
External component
3.5 mm stereo mini plug