Panasonic KX-NCP0158 Quick Installation Manual page 41

6. To set the default IP address mode, set the DIP switch no.7 (Fixed IP Setting Mode Switch) of the
IP-CS to the ON position.
Note
For details about the DIP switches of the IP-CS, refer to "Setting and Installing the CS Temporarily
for Site Survey".
7. Click Next.
8. Connect the IP-CS that you want to register to the PC using the switching hub, then supply electricity
to the IP-CS using the AC adaptor, PoE hub, or PoE adaptor.
The IP-CS starts with its default IP address (192.168.2.101).
9. Click Next.
10. Assign the IP addressing information automatically through a DHCP server or enter it manually.
Note
It is not necessary to configure the PBX IP Address setting regardless of whether or not you are
using a DHCP server, because it is detected automatically.
When using a DHCP server:
a.
Select Enable for the DHCP Client setting.
b.
Click Next.
A dialogue box will appear.
When not using a DHCP server:
a.
Select Disable for the DHCP Client setting.
b.
In the IP Address box, type the IP address of the
IP-CS.
*1
c.
In the Subnet Mask box, type the subnet mask
address of the network.
d.
In the Default Gateway box, type the IP address
of the default gateway.
e.
Click Next.
A dialogue box will appear.
11. Click Yes.
If the assignment is successful, the dialogue box will show "Setup Successful!".
12. Click Next Device to assign the IP addressing information for other IP-CSs, or click Main Screen to
return to the main screen.
13. Click Exit.
14. Disconnect the IP-CS from the AC adaptor, PoE hub, or PoE adaptor to stop supplying electricity.
15. Return the Fixed IP Setting Mode switch of the IP-CS to the OFF position.
*1 Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2 Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
Note
For information on other parameters, refer to "D Information about IP Terminal Maintenance Console".
*2
*1
7 Connecting IP Cell Stations
Quick Installation Guide 41