Lighting & Shutdown Instructions - Dyna-Glo RA18LPDG User Manual

PROPANE CONSTRUCTION HEATER
1. STOP! Read and head warnings and cautions on the side of the heater.
2. Check that the gas supply to the heater is on.
3. Push in gas control knob slightly and turn clockwise
Note: knob cannot be turned from "PILOT"
Do not force.
 :DLW ¿YH  PLQXWHV WR FOHDU DQ\ JDV 7KHQ VPHOO IRU JDV LQFOXGLQJ QHDU WKH ÀRRU LI \RX VPHOO JDV 6723
Follow the leak checking section in the manual. if you do not smell gas, go to next step.
 3XVK LQ WKH JDV FRQWURO NQRE VOLJKWO\ DQG WXUQ FRXQWHUFORFNZLVH
DQG GHSUHVV IRU  VHFRQGV %
Note: 7KH ¿UVW WLPH WKDW WKH KHDWHU LV RSHUDWHG DIWHU FRQQHFWLQJ WKH JDV VXSSO\ WKH FRQWURO NQRE VKRXOG EH
depressed for at least 30 seconds. This will allow air to bleed from the gas system.
 'HSUHVV FRQWURO NQRE ZKLOH GHSUHVVLQJ WKH SLH]R LJQLWRU EXWWRQ  7KLV VKRXOG FDXVH WKH VSDUN IURP WKH
SLH]R LJQLWRU WR OLJKW WKH SLORW JDV .HHS FRQWURO NQRE GHSUHVVHG WKLUWU\  VHFRQGV EHIRUH UHOHDVLQJ
,I WKH SLORW GRHV QRW OLJKW GHSUHVV WKH FRQWURO NQRE DQG WXUQ WR WKH ³2))´
7. When pilot is lit, turn the knob counterclockwise
or HIGH . (C)
FIGURE 3
LIGHTING INSTRUCTIONS
position to "OFF"
(A)
to "OFF" position. (A)
unless the knob is pushed in slightly.
WR ³3,/27´
to desired heat level, LOW
(B)
(C)
SRVLWLRQ
SRVLWLRQ 5HSHDW VWHSV  DQG 
, MEDIUM ,
10