Charcoal Filters; Maintenance And Cleaning; Metal Grease-Trapping Filters - FALMEC down draft Instruction Booklet

Code Change
(only in case of
malfunction)
H
FILTERS
1. METAL FILTERS
Open the panel fixed to the body of the range hood with magnets (see ill.H3). To remove
the metal grease-trapping filter (A) pull on the filter handle.
Hoods with perimeter suction:
- Open the panel (see fig. 1). Use handle A to remove the metal grease filter.

2. CHARCOAL FILTERS

To replace the charcoal filters, proceed as follows: remove the metal filters as indicated
above. The two charcoal filters can now easily be accessed. See figure H3 for assembly/
replacement.
To order new charcoal filters, contact your distributor/dealer.
VALID ONLY FOR ITALY: download the appropriate order form from: www.falmec.com (access
the assistance drop-down menu).
Carbon filter code for downdraft: 101080159.
I
LIGHTING
The range hood is equipped with high efficiency, low consumption LED strips with extremely
long duration under normal use conditions. LED strip replacement must only be carried out by
qualified technicians. The LED strip is accessible by removing the VL (LG) panel as indicated
in illustration I1.
L

MAINTENANCE AND CLEANING

Constant maintenance ensures the correct operation and efficiency of the appliance over
time. Special attention should be paid to the metal grease-trapping filters and the charcoal
filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do
not accumulate on the range hood, with the consequent risk of fire.

1. METAL GREASE-TRAPPING FILTERS

These trap the fat and grease particles suspended in the air, and therefore should be
washed every month in hot water and detergent, without bending them. Wait until they
are completely dry before repositioning them. To remove and replace these filters, see
the instructions in point H1. This operation should be performed at regular intervals.
2. CHARCOAL FILTERS
These trap the odours present in the stream of air that passes through them. The air is puri-
fied by passing a number of times through the filters and being recirculated into the kitchen.
The charcoal filters cannot be cleaned, and should be replaced on average every 3-4 months
(according to use). To replace the charcoal filters, see the instructions in point H2.
18
Press the "Luce" (Light) key together with the "Timer" key of the remote control
until the blue LED begins to slowly flash. If the "-" key of the remote control
is pressed within 5 seconds, the new code will be generated and memorised.
Memorisation is confirmed by 3 brief flashes of the LED.
To return to the default code, apply pressure on the "-" key together with the "+"
key for over 5 seconds. Memorisation of the default code will be signalled with 3
brief flashes of the LED.
Each time that a new code is generated or that the default code is set in the
remote control, it is necessary to also carry out the previously described Remote
Binding (Light Key of the pushbutton) procedure.
REMOVING AND REPLACING'S INSTRUCTIONS
ASSEMBLY AND REPLACEMENT