CONNECTIONS
● Before moving or installing the product, be sure to turn off the power and disconnect the power cord.
● If the main unit is powered off,the wireless subwoofer will in standy mode and the STnDBy LeD on the
front will blink red directly.(no blue LeD).
● If you use a device that uses the same frequency (2.4GHz) as the Soundbar near the Soundbar,
interference may cause some sound interruption.
● The maximum transmission distance of the wireless signal between the main unit and subwoofer is about
32.8 ft, but may vary depending on your operating environment. If a steel-concrete or metallic wall is
between the main unit and the wireless subwoofer, the system may not operate at all, because the wireless
signal cannot penetrate metal.
● If the main unit doesn't make a wireless connection, follow steps 1-5 on the previous page to re-set the
connection between the main unit and wireless subwoofer.
● The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and
moisture.
● for optimal listening performance, make sure that the area around the wireless subwoofer location is clear
of any obstructions.
ConneCTInG THe SWa-8000S
(SoLD SeParaTeLy)
● expand to true wireless surround sound by connecting the Samsung Wireless rear Speaker Kit
(SWa-8000S) to your Soundbar. (Sold separately)
● Before connecting to the Wireless receiver module, connect your subwoofer first.
● Use the speaker cable to connect the wireless receiver module to the speakers.
● Plug the power cable into a power outlet. The LeD turns on.
1. While the main unit is powered off (in STanDBy mode), press and hold the
5 seconds.
2. The iD Set message appears on the Soundbar's display.
3. Plug the power cord of the Wireless receiver module (SWa-8000S) into an aC wall outlet.
4. Turn on your Soundbar when the link indicator (Blue LeD) on the SWa-8000S flickers fast.
5. When the link indicators (Blue LeDs) on your subwoofer and the SWa-8000S flash and then glow continuously, the
SWa-8000S is completely connected.
● This may take a few minutes.
● once connected, your Soundbar and the Wireless receiver module are automatically reconnected even
after you turned them off and then on.
(mute) on the remote control for
18