Package Contents; Description (Fi G. A); Assembly And Adjustment - DeWalt DE0772 Manual

Package contents

The package contains:
1 Digital laser detector
1 Clamp
1 Battery
1 Instruction manual
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fi g. A)
This attachment is intended to be used with a rotary
laser. It will not work with a stationary laser.
1 Power/Audio signal volume button
2 Accuracy mode button
3 Display
4 Beam detection window
5 Battery compartment cover
INTENDED USE
Your DE0772 digital laser detector has been
designed to extend the capabilities of your D
rotary laser. The detector helps locating the position
of a laser beam in bright light conditions or over long
distances. It produces both visual and audio signals
as the rotating laser beam crosses the detector.
The attachment can be used both indoor and outdoor
whenever it is diffi cult to locate the laser beam.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
The digital laser detector is a professional power tool.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators
use this tool.

Assembly and adjustment

Also refer to the manual of the tool to be
used with this attachment.
Replacing batteries (fi g. A)
The attachment uses batteries of type 6LR61.
• Open the battery compartment cover (5) (fi g. A).
• Replace the battery. Make sure the new battery is
placed according to the orientation as indicated.
• Close the battery compartment cover.
Installing the attachment (fi g. A, C1 & C2)
The attachment can be used with or without the
supplied clamp. The attachment can also be held by
hand, e.g. against walls.
When used with the clamp, the attachment can be
mounted to a grade rod, levelling pole, stud or post.
• Push in the release button (13) and slide the
attachment over the rails (14) until the latch (15)
engages in the recess (16) (fi g. C1).
• Open the jaws of the clamp by loosening the
clamp knob (17) (fi g. C2).
• Hold the attachment at the desired position e.g.
against a grade rod.
• Tighten the knob (17).
Instructions for use
WARNING:
• Always observe the safety instructions
and applicable regulations.
• Before fi rst use, remove and discard
the protective tape from the screens.
WALT
E
Switching on and off (fi g. A & B)
• To switch on, press the button (1) (fi g. A).
The power-on sign (6) appears on the display (3)
(fi g. B).
• After it has not been used for about 30 minutes,
the attachment switches off automatically.
Setting the audio signal volume (fi g. A & B)
• Press the button (1) (fi g. A). The volume will cycle
from "high" to "low" to "off" each time the button
is pressed. The volume level is indicated by the
volume sign (7) on the display and the number of
half circles accompanying the sign (fi g. B).
Setting the detection accuracy (fi g. A & B)
The attachment can be used in 2 accuracy modes
(fi g. B):
- Level detection at max. 3 mm accuracy
difference. This mode is indicated by the sign
(11) on the display.
- Level detection at max. 1 mm accuracy
difference. This mode is indicated by the sign
(12) on the display.
• To change the mode, press the button (1) (fi g. A).
E N G L I S H
13