Motorola AP-7131 Release Notes page 3

PoE & Gigabit Ethernet Port Labels
The AP-7131 features upgraded Gigabit Ethernet (GE) ports. These ports are labeled
as follows:
- GE1/ PoE: GE1 is the LAN Port and supports 802.3af, 802.3at (draft) PoE.
- GE2: GE2 is the WAN port.
Single radio models can operate fully with 802.3af power sources. Dual radio
models can also power up two radios and GE1 interface with 802.3af power
sources. At higher power levels, both radios and ethernet interfaces are fully
functional in the dual radio models. Both models can also operate using an A/C
power supply.
The following table shows the radio and LAN resources available under various
power configuration modes for the dual radio model
Available Power
13 watts
Power Status: 3af
18 watts
Power Status: Mid Power
24 watts or External power supply
Power Status: Full Power
When a Motorola 802.3af power injector (AP-PSBIAS-T-1P-AF) is used with AP-
7131, then the GE1 or LAN1 port will be limited to 10/100 Mbps. Motorola
recommends the 802.3at (Draft) power injector (AP-PSBIAS-1P3-AFR) to be used
with AP-7131.
Access Points Hardware/ Software Compatibility Matrix
The following table shows the compatibility between AP-7131 hardware and firmware
revisions.
AP-7131 Hardware Revisions
AP-7131 Firmware Revisions
Radio
Resources
2 Radios
2 Radios
2 Radios
Hardware RevA
3.0.0
3.0.1
3.0.2
3.1.1 (Adaptive AP only
with Wi-NG version 1.3.1)
3.2.0
Ethernet Port
Configuration
GE1 10/100/1000
GE1 10/100/1000
GE2 10/100
GE1 10/100/1000
GE2 10/100/1000
Hardware RevB or later
3.0.1
3.0.2
3.1.1 (Adaptive AP only
with Wi-NG version 1.3.1)
3.2.0