Connection Of Dect Portable Stations; Overview - Panasonic KX-TDA100 Installation Manual

2.8 Connection of DECT Portable Stations

2.8 Connection of DECT Portable Stations
2.8.1

Overview

The following equipment is required to connect the wireless system:
CS: Cell Station (KX-TDA0142CE/KX-TDA0141CE)
KX-TDA0142CE Using a CSIF Card
This unit determines the area covered by the wireless system. Up to 4 calls can be made at the same
time through each CS.
• CSIF4 (KX-TDA0143)
One CSIF4 card supports up to 4 Cell Stations.
• CSIF8 (KX-TDA0144)
One CSIF8 card supports up to 8 Cell Stations.
KX-TDA0141CE Using a DHLC/DLC Card
This unit determines the area covered by the wireless system. Up to 2 calls can be made at the same
time through each CS.
Note for users in Europe
This Cell Station Unit for DECT is for connection to Panasonic PBXs in use in European countries.
PS: DECT Portable Station (KX-TCA155/KX-TCA255/KX-TD7590/KX-TD7580)
The KX-TDA100 and KX-TDA200 can support up to 128 PSs. For more details about the PS, refer to the
PS Operating Instructions.
RF Specification
Radio Access Method
Frequency Band
Number of Carriers
Carrier Spacing
Bit Rate
Carrier Multiplex
Frame Length
Modulation Scheme
Data Coding for Modulator
Voice CODEC
Transmission Output
*1
KX-TDA100BX/KX-TDA200BX: 1880 MHz to 1895 MHz
148 Installation Manual
Item
MultiCarrier TDMA-TDD
1880 MHz to 1900 MHz
*2
10
1728 kHz
1152 kbps
TDMA, 24 (Tx12, Rx12) slots per frame
10 ms
GFSK
Roll-off factor=0.5 50 % roll-off in the transmitter
Differential Coding
32 kbps ADPCM (CCITT G.721)
Average 10 mW
Peak 250 mW
Description
*1