Motorola MSC8101 ADS User Manual page 79

TABLE B1-2. P1 - System Expansion - Interconnect Signals
Pin No. Signal Name
A26 5V0
A27
A28
A29
A30
A31
A32
B1 GND
B2
B3
B4 TSTAT0
B5 TSTAT1
B6 TSTAT2
B7 TSTAT3
B8 TSTAT4
B9 TSTAT5
B10 TSTAT6
B11 TSTAT7
B12 TOOLREV0
B13 TOOLREV1
B14 TOOLREV2
B15 TOOLREV3
B16 EXTOLI0
B17 EXTOLI1
B18 EXTOLI2
B19 EXTOLI3
B20 PORSTb
B-78
Freescale Semiconductor, Inc.
Attribute
P +5V Supply. Connected to ADS's 5V plane. Provided as power
supply for external tool. For allowed current draw, see
1. "Off-Board Application Maximum Current Consumption"
on page 66
P Digital Ground. Connected to main GND plane of the ADS.
I,P.U. Tool Status (0
be read via BCSR2 of the ADS. These lines are pulled-up on the
ADS, by 10 KΩ resistor's network. See also
Board Application Maximum Current Consumption" on
page 66
I,P.U. Tool Revision (0
tool with the Tool Revision Code, to be read via BCSR2 of the
ADS. These lines are pulled-up on the ADS, by 10 KΩ resistor's
network. See also
page 58
I,P.U. External Tool Identification (0
an external tool with the Tool Identification Code, to be read via
BCSR2 of the ADS. These lines are pulled-up on the ADS, by 10
KΩ resistor's network. See also
Description" on page 58
I/O,P.U. Power-On-Reset. This line is connected to open drain output of
voltage detector device. When power-up is executed this line
asserted low during apr. 800 ms. Off-board power-on-reset may
be provided when this pin is driven by external O.D. (without pull-
up resistor) logic. Failure to do so might result in permanent
damage to the MSC8101 and / or to ADS logic.
MSC8101ADS RevB User's Manual
For More Information On This Product,
Go to: www.freescale.com
Description
.
a
:7). This lines may be driven by an external tool to
.
a
:3). This lines should be driven by an external
TABLE 5-12. "BCSR2 Description" on
.
a
:3). This lines should be driven by
.
TABLE 7-
TABLE 7-1. "Off-
TABLE 5-12. "BCSR2
MOTOROLA