Bosch GWS 14,4 V Operating Instructions Manual page 13

Use only grinding tools with a permissible
speed at least as high as the no-load speed of
the machine.
Check grinding tools before using them. The
grinding tool must be mounted properly and
able to move freely. Carry out a trial run with-
out load for at least 10 seconds. Do not use
damaged, out-of-centre or heavily vibrating
grinding tools.
Protect the grinding tool from impact, shock
and grease.
Observe the manufacturer's instructions for
mounting and using grinding tools.
Apply the machine to the workpiece only when
switched on.
Keep hands away from rotating grinding tools.
Pay attention to the direction of rotation. Al-
ways hold the machine so that sparks and
grinding dust fly away from the body.
When grinding metal, flying sparks are pro-
duced. Take care that no persons are endan-
gered. Due to danger of fire, no combustible
materials should be located in the vicinity
(spark flight zone).
Hold the power tool only by the insulated
gripping surfaces, when performing an op-
eration where the cutting tool may run into
hidden wiring.
Contact with a "live" wire will make exposed
metal parts of the tool "live" and shock the op-
erator.
Use appropriate detectors to determine if
utility lines are hidden in the work area or
call the local utility company for assist-
ance.
Contact with electric lines can lead to fire and
electric shock. Damaging a gas line can lead
to explosion. Penetrating a water line causes
property damage.
Blocking the cutting disc leads to jerking reac-
tion forces on the machine. In this case switch
off the machine immediately.
Never use cutting discs for rough grinding. Do
not exert any lateral pressure on the cutting
discs.
13 • 1 609 929 C83 • TMS • 26.04.02
Caution! The grinding tool runs on after the
machine is switched off.
Do not clamp the machine in a vice.
Do not attach the machine to yourself for
transportation.
Danger of injury caused through unintentional
starting of the grinding tool.
Never allow children to use the machine.
Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.
Battery and Battery Charger
The enclosed operating instructions for the
battery charger must be read carefully!
The battery and battery charger are designed
to match each other. When charging the bat-
tery, use only a Bosch battery charger de-
signed for it with a charging voltage that corre-
sponds with the battery (see type plate). Com-
bining different rated voltages causes damage
to the battery and the battery charger.
Allow a heated battery to cool before charging.
Protect the battery from heat and fire: Danger
of explosion! Do not place the battery on radi-
ators or expose to strong sun rays for a longer
time; temperatures over 50 °C cause damage.
Do not open the battery, and protect it from im-
pact. Store in a dry and frost-free place.
Cover the contacts of a removed battery. Dan-
ger of fire results when shorted by a metal ob-
ject!
Do not dispose of the battery in household
waste or discard into fire or water.
Intended Use
The machine is intended for roughing and cutting
of metal materials. With corresponding diamond
cutting discs, the machine may also be used to
cut tiles. When using the rubber sanding pad (ac-
cessory), the machine can also be used to sand
surfaces.
English - 2