Reading Inputs - Nokia 12 GSM MODULE REMOTE I/O Control Manual

Table 6. Commands for the password control.
Command Type
Changing Password
OK Response:
Fail Response:
Activating Password
Property
OK Response:
Fail Response:
Deactivating
Password Property
OK Response:
Fail Response:
Note: An indication of a password change is only sent to the phone number where
the change was requested.
9.3.2

Reading Inputs

Use the Input_Get X commands for reading inputs, that is the state or value of
a device. Note that all example control messages in this chapter use the
"term123" identifier string and the password property is set off (see Table 7)
A response depends on the pin. There are three analog inputs (1-3) and nine
digital inputs (4-11) in the Nokia 12 GSM Module M2M system interface. You
can also specify an alias for the response (see chapter 9.2).
Command
term123 passWORD
Change_PWord wordPASS
CHANGE_PWORD wordPASS: OK
CHANGE_PWORD: FAILED
term123 Change_PWord
wordPASS
CHANGE_PWORD wordPASS: OK
CHANGE_PWORD: FAILED
term123 wordPASS
Change_PWord
CHANGE_PWORD: OK
CHANGE_PWORD: FAILED
Comments
The example
changes the
password from
'passWORD' to
'wordPASS'
The example
changes an empty
password to
'wordPASS'
The example
changes the
password from
'wordPASS' to an
empty password
30/49