Status Messages - Nokia 12 GSM MODULE REMOTE I/O Control Manual

OUTPUT_SET ALL OFF
OUTPUT_INVERT ALL
OUTPUT PULSE ALL ON
*
OUTPUT_PULSE ALL
OFF *
INPUT_GET x
INPUT_GET ALL
INPUT_GET_CHANGE x
INPUT_GET_CHANGE
ALL
INPUT CHANGE CANCEL
x
INPUT CHANGE CANCEL
ALL
CHANGE_PWORD
OUTPUT PULSE CANCEL
x
OUTPUT PULSE CANCEL
ALL
LOCATION_GET
* The duration of the pulse will be added to the control message after the corresponding command. The format is the
following:
Output_Pulse 1 On <days>d<hours>h<minutes>m<seconds>s
for example Output_Pulse 1 On 5m30s
For more information about pulse commands, see Chapter 9.3.7.
** The location support needs external GPS device to be connected to the Nokia 12 GSM Module. The Nokia 12
GSM Module supports NMEA-0183 protocol.
9.2

STATUS MESSAGES

The Nokia 12 GSM Module supports the status messages listed in
Table 5. You can define an alias for each of them. The messages will be sent
as responses to device query control messages according to the current
command and device state.
Set all outputs OFF
Inverts all outputs
All outputs pulse ON *
All outputs pulse OFF *
Return a voltage of input x, x = pin number 1-11
Return states of all inputs
Subscribe a voltage limit alarm of input x, x = pin number 1-
11
Subscribe a input state change of all inputs
Cancel input x subscription, x = pin number 1-11
Cancel all input subscriptions
Change password
Cancel output x pulse, x = pin number 1-9
Cancel all outputs
Get location information **
28/49