Setting Up The Equipment; Opening The Installation Menu - Furuno FR-8122 Installation Manual

3. SETTING UP THE EQUIPMENT

3.1 Opening the Installation Menu

After you have installed the equipment, set up the equipment as follows.
1. Press the MENU key. The main menu appears on the screen.
2. Rotate the trackball downward to choose Installation. The installation menu appears in
gray to right side of the screen.
3. While pressing down the CANCEL/HL OFF key, press the MENU key five times.
Menu
Target Trails
Mark
Custom 1
Custom 2
Custom 3
Tuning
Target
ARP
AIS
GPS
System
Initial
Factory
Installation
Sector Blank 1
4. Press the ENTER key. The highlighted cursor appears in the Installation menu.
5. Rotate the trackball downward or upward to choose an item in the Installation menu.
6. Press the ENTER key to show setting window.
7. Rotate the trackball downward or upward to choose an option.
8. Press the ENTER key to set it.
9. Finally, press the MENU key to close the main menu.
Basic settings
Language: The default setting is English. Choose an appropriate language.
Purpose: Choose the purpose of this radar among River, Sea and IEC. The default setting
is Sea.
River: To use this radar on the river
Sea: To use this radar at oceans.
IEC: To use this radar as the type approved radar.
Type: Choose type of this radar among 8062 (6 kW radar), 8122 (12 kW radar) and 8252
(25 kW radar) to coincide with the specifications of the antenna unit. The default
setting is 8062. Unsuitable setting may result malfunctions.
Installation
Language
Purpose
Type
View Position
Input Source
Antenna Height
Heading Adjust
Manual Timing Adjust
Tuning Initial Adjust
Manual MBS Adjust
Auto Installation Setup
Local Time Offset
Total TX Time
(Total On Time
[ENTER]: Enter [CANCEL/HL OFF]: Back
[MENU]: Exit
* : Displayed when scrolled.
: English
: Sea
: 8062
: Center
: Main
: 5 m
°
: 0
: 0
: 0
: - 0.1 H
: 000000.5 h
: 000000.6 h)*
3-1