Drive Belt - Can-Am Maverick Operator's Manual

tmo2013-003-061_a
CVT COVER TIGHTENING SEQUENCE
CVT COVER SCREWS
Tightening torque

Drive Belt

Drive Belt Removal
NOTICE
In case of a drive belt fail-
ure, the CVT, cover and air outlet
must be cleaned.
CVT COVER
Remove
Open driven pulley.
REQUIRED TOOL
PULLER/LOCKING
TOOL
(P/N 529 036 098)
Screw tool (supplied in tool kit) in the
threaded hole of driven pulley and
tighten to open the pulley.
7 N•m ± 0.8 N•m
(62 lbf•in ± 7 lbf•in)
.
_______________
MAINTENANCE PROCEDURES
Vmr2012-018-005_a
TYPICAL
1. Puller/locking tool
2. Fixed sheave of driven pulley
To remove belt, slip the belt over the
top edge of fixed sheave, as shown.
Vmr2012-018-006_a
Drive Belt Inspection
For drive belt inspection refer to
BELT INSPECTION
MAINTENANCE PROCEDURES
section.
Drive Belt Installation
For installation, reverse the removal
procedure. Pay attention to following
details.
The maximum drive belt life span is
obtained when the drive belt has the
proper rotation direction. Install it
so that the arrow printed on belt is
pointing towards front of the vehicle,
viewed from top.
DRIVE
PERIODIC
in the
sub-
95