Nokia 5800 XpressMusic User Manual page 74

Connectivity
WLAN network name
●
Search for networks. If you select an existing network,
WLAN network mode and WLAN security mode are
determined by the settings of its access point device.
Network status — Define whether the network name is
●
displayed.
WLAN network mode
●
hoc network and to allow devices to send and receive data
directly; a WLAN access point device is not needed. In an
ad hoc network, all devices must use the same WLAN
network name.
WLAN security mode
●
WEP, 802.1x (not for ad hoc networks), or WPA/WPA2. If
you select Open network, no encryption is used. The WEP,
802.1x, and WPA functions can be used only if the network
supports them.
Homepage — Enter the web address of the starting page.
●
Use access point — Select
●
want the device to ask for confirmation before the
connection using this access point is created or
Automatically if you want the device to connect to the
destination using this access point automatically.
To enter the settings for the selected security mode, select
WLAN security settings.
Security settings for WEP
WEP key in use — Select the wired equivalent privacy
●
(WEP) key number. You can create up to four WEP keys. The
same settings must be entered on the WLAN access point
device.
74
— Select Enter manually
— Select Ad-hoc to create an ad
— Select the encryption used:
After confirmation
or Authentication type
●
authentication type between your device and the WLAN
access point device.
WEP key settings
●
the key),
WEP key
Security settings for 802.1x and WPA/WPA2
WPA/WPA2
●
to use an extensible authentication protocol (EAP) plug-in,
or Pre-shared key
Complete the appropriate settings:
EAP plug-in settings
●
to the instructions from your service provider.
Pre-shared key
●
password must be entered on the WLAN access point
device.
if you
WPA2 only mode
●
allowed to establish a connection in this mode.
Advanced WLAN settings
Select Options
following:
IPv4 settings
●
subnet IP address, the default gateway, and the IP
addresses of the primary and secondary DNS servers.
Contact your internet service provider for these addresses.
IPv6 settings
●
Ad-hoc channel
●
number (1-11) manually, select
— Select Open
— Enter WEP encryption
WEP key format (ASCII
(the WEP key data in the selected format).
— Select the means of authentication:
to use a password.
— Enter the settings according
— Enter a password. The same
— Only WPA2 enabled devices are
Advanced settings
>
— Enter the IP address of your device, the
— Define the type of DNS address.
(only for Ad-hoc) — To enter a channel
User
© 2008 Nokia. All rights reserved.
or Shared for the
(length of
or Hexadecimal), and
EAP
and from the
defined.