To change the priority of an access point within the group,
select
Options
Organise
>
Packet data access points
Select
Menu
Settings
>
Destinations
Access
>
on the screen.
To edit a packet data access point, open one of the access
point groups, and select an access point marked with
Follow the instructions from your service provider.
Select from the following:
Access point name
— You obtain the access point name
●
from your service provider.
User name
— The user name may be needed to make a
●
data connection, and is usually provided by your service
provider.
Prompt password
— If you must enter the password
●
every time you log in to a server, or if you do not want to
save your password in the device, select Yes.
Password
— A password may be needed to make a data
●
connection and is usually provided by your service
provider.
Authentication
— Select
●
password encrypted or
encrypted when possible.
Homepage
— Depending on the access point you are
●
setting up, enter the web address or the address of the
multimedia message centre.
© 2008 Nokia. All rights reserved.
Change
priority.
>
and
Connectivity
>
point, and follow the instructions
Secure
to always send your
Normal
to send your password
Use access point
●
want the device to ask for confirmation before the
connection using this access point is created, or
Automatically
destination using this access point automatically.
Select
Options
>
following:
Network type
●
transfer data to and from your device. The other settings
.
depend on the selected network type.
Phone IP address
●
of your device.
DNS addresses
●
and secondary DNS servers, if required by your service
provider. To obtain these addresses, contact your internet
service provider.
Proxy server address
●
server.
Proxy port number
●
server.
WLAN internet access points
Select
Menu
Settings
>
Destinations
Access
>
on the screen.
To edit a wireless LAN (WLAN) access point, open one of the
access point groups and select an access point marked with
.
Follow the instructions from your WLAN service provider.
— Select
After confirmation
if you want the device to connect to the
Advanced settings
and from the
— Select the internet protocol type to
(for IPv4 only) — Enter the IP address
— Enter the IP addresses of the primary
— Enter the address of the proxy
— Enter the port number of the proxy
and
Connectivity
point, and follow the instructions
Connectivity
if you
>
73