Removing The Windows-Button Board; Prerequisites; Procedure - Dell 13 7000 series Service Manual

Removing the Windows-
button board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.

Prerequisites

1 Remove the
2 Remove the battery.
3 Remove the
4 Follow the procedure from step 1 to step 2 in
panel".

Procedure

CAUTION: Place the display-panel assembly on a soft and clean
surface to avoid scratching the display.
1 Place the display-panel assembly face down on a flat surface.
2 Remove the screw that secures the Windows-button board to the display
bezel.
3 Turn the Windows-button board over.
4 Peel off the tape from the connector on the Windows-button board.
5 Lift the latch and disconnect the Windows-button board cable from the
Windows-button board.
computer. After working inside your
base cover.
display assembly.
After working inside your
"Removing the display
87