Assembling And Using Your Food Processor - Oster Versa Performance Manual

Assembling and Using Your Food Processor

1. Before assembly, make sure Adaptor is operating correctly. Unplug Motor
Base during assembly.
2. Place Adaptor in bowl and turn counterclockwise to lock.
3. Place Bowl with Adaptor on Motor Base.
To Chop or Mince
4. Hold S Blade by the plastic Center Hub and place over post of Bowl.
Caution: Blade is very sharp, handle carefully. Rotate the S Blade to make
certain it is seated on the post as far as it will go. Always place S blade in
Food Processor before adding ingredients.
5. Place food in Processing Bowl. Food to be processed should always be cut
into 1-inch (2.5 cm) pieces.
6. Using alignment marks on the lid, place cover on bowl and press down
firmly while turning counterclockwise to lock.
DO NOT OPERATE UNIT UNLESS COMPLETELY ASSEMBLED
7. Turn unit "ON." (Select Pulse, Low, or Med setting on the Motor Base.)
ALWAYS HOLD FOOD PROCESSOR FIRMLY WITH ONE HAND
WHEN STARTING UNIT AND WHEN PROCESSING. Process until
desired results are achieved by running the unit continuously or Fast
Pulsing. Fast Pulsing is the technique used to control the size of the food
being processed with the Food Processor Accessory. Press and release the
Pulse button very quickly. Refer to Processing Chart for proper techniques,
quantities and end results.
NOTE: Do not select High speed, Programmed settings, or Reverse with the
food processor accessory.
To Slice or Shred
8. Place Blade Shaft over post. Place Slicing/Shredding Disk over Blade Shaft
with the blade of your choice facing up. Caution: Blade is very sharp, handle
carefully.
9. Using alignment marks on the lid, place cover on bowl and press down
firmly while turning counterclockwise to lock.
10. Load the feed tube with ingredients before turning the food processor "ON".
11. Rest the Food Pusher in the feed tube. Turn unit "ON". (Select medium
12