Hubsan X4 User Manual page 14

www.hubsan.com
7 ADVANCED PERFORMANCE SETUP
7.1 Reverse Setup
7.1.1 Elevator Reverse Setup
Press and hold the Elevator stick for 2 seconds to enter the settings menu. The LCD will display "SE".
Press the Elevator Trim up or down to reverse the channel, and then press and hold the Elevator stick
T
X
M1
7.1.2 Aileron and Rudder Reverse Setup
Rudder Trim left or right to reverse the channel, and then press and hold the Elevator stick for 2
T
X
M1 M2
(a)Aileron Trim
7.2 Normal and Expert Flight Modes
The X4 is factory set for Normal Mode flying, and it will always power up in Normal Mode. Though
Mode is activated.
12
H107
THE HUBSAN X4
Elevator Trim
M2
T
X
M1 M2
(b)Rudder Trim
T
X
M1 M2
Normal mode
7.3 Sensitivity Setup
Hold down the Elevator stick for 2 seconds to
enter the setup (SE) menu. Press the base of the
throttle stick, the three-point dotted line starts
to flash (see picture (a) below). Press it again to
switch to different channels. Use the (a) Rudder
Trim, (b) Elevator Trim, or (c) Aileron Trim to
change the sensitivity values shown on the LCD
and then hold down the Elevator stick for 2
sensitivity increases with higher value settings.
T
X
M1 M2
Flashing
(a) Rudder Sensivity Adjustment
T
X
M1 M2
(c) Aileron Sensivity Adjustment
www.hubsan.com
T
X
M1 M2
Expert mode
MODE 2 MODE 1
T
X
Flashing
M1 M2
(b) Elevator Sensivity Adjustment
Flashing
13
H107
THE HUBSAN X4