System Information; Software Upgrade; Embedded Conax; Troubleshooting - Samsung DCB-B263Z Instructions For Use Manual

MF68-00411A_GB 1/23/07 7:38 PM Page 28
OPERATING THE RECEIVER

4.5 System Information

If you have to contact your service provider or a service center
they might ask for information available from this menu.
Place the cursor on this sub menu and press the OK key.
The following will be the on-screen display.
● Press YELLOW (ALT) key for help.

4.6 Software Upgrade

You can download and upgrade the system software of the receiver through a specific channel
through a specific channel designated by the broadcaster.
The distributor will provide you with more information about that.
If you select to download a new software version, all your previous settings, access code and
favourite channels etc. will be erased! Downloading may take a while. During downloading, don't
turn off the receiver.
● Press YELLOW (ALT) key for help.

5. Embedded Conax

When you insert the card supplied from Conax, you can see
the program for Conax.
GB-28
D I G I T A L
Problem
No display LED on
the front panel;
No power supply
No pictures on the screen
No sound
Remote Control does not
operate directly
Poor picture quality
On-Screen Error Message
"Searching for signal"
On-Screen Error Message
"Channel data does not
exist."
On-Screen Error Messages:
"Please check the
Smartcard";
"Please insert the
Smartcard".
On-Screen Error Messages:
"No access"

DISPOSAL

The device, packaging material (e.g. Styrofoam) and the batteries must never be
disposed of with household refuse.
Please obtain appropriate information about the regulations in your community, and
dispose of all refuse in accordance with regulations at the separate locations provided.
C A B L E R E C E I V E R

TROUBLESHOOTING

Possible cause Solution of the problem
Power cord Power cord plug in correctly
not plugged in correctly
Receiver in Standby mode; Set receiver to "On";
SCART not connected tightly Check connection and correct;
to video output of television;
incorrect channel or video Check channel and video output and
output selected on television correct (TV instruction manual)
Audio cord connected Check connection and correct;
incorrectly;
Volume level = 0; Increase volume on television set;
Muting active Press the MUTE key
Batteries dead or inserted Point remote control towards the
incorrectly Receiver.
Replace batteries or insert correctly
Signal strength too low Check the signal strength in
the "Installation" menu, correct
alignment of your signal cable
Antenna cable not connected Check connection and correct;
or not tight;
incorrect position of the Check position and correct,
signal; Check the signal strength in
the "Installation" menu
Receiver not yet set Scanning of in "Installation" menu
Smartcard: (depend on model)
- not plugged in correctly; Check the Smartcard.
- not plugged in. "Insert the Smartcard."
No access to this channel Check that you subscribe to this channel.
If the STB has been switched off for a
longer period of time, turn on the STB,
select any channel, and wait for
authorization for up to 60 minutes.
GB-29