Connecting Your "Stb - Samsung DCB-B263Z Instructions For Use Manual

MF68-00411A_GB 1/23/07 7:38 PM Page 6

CONNECTING YOUR "STB"

1. LOCATION OF THE RECEIVER
Your STB should be placed under proper ventilation.
Don't put in completely enclosed cabinet that will restrict the flow of air,
resulting in overheating.
The location should be safeguarded from direct sunlight, excess moisture,
rough handling or household pets.
Avoid stacking other electronic components on the top of the receiver.
2. CONNECTING THE RECEIVER WITH CABLE SYSTEM
After installing your cable system, connect the coaxial cable to "CABLE IN" terminal
marked at the rear of the STB.
All cable connectors should be finger tightened; do not use any kind of wrench while
tightening connectors. The cable should be 75ohm impedance coaxial cable.
3. CONNECTING THE RECEIVER TO TV
To connect the receiver with your television, you can use Scart Cable.
In the case of connecting your TV through SCART cable, connect the SCART
connector marked AV1(TV) to the respective SCART port on the TV.
4. CONNECTING YOUR VCR
To connect a VCR, the STB has been provided with SCART at the rear marked
"AV2(EXT)".
Using a SCART connector, the VCR can be connected to the receiver.
5. INSERTING SMARTCARDS FOR CONAX SERVICES
In order to view a scrambled service, you need to have a valid Smartcard.
This STB has the Conax embedded to view Conax programmes.
N N o o t t e e : Insert the Smartcard with the gold coloured chip facing downwards.
GB-6
D I G I T A L
Connecting Figure
Signal Cable
N N o o t t e e : The Mains plug is used as a disconnect device and shall stay readily operable at
any time.
C A B L E R E C E I V E R
CONNECTING YOUR "STB"
GB-7