Troubleshooting - CleanForce CF1800HD Operating Manual

Disconnect the machine from the power source before making any repairs.
Symptom
Motor does not run
when "ON", fully con-
nected and trigger
depressed.
Unit does not reach high
pressure.
TrOUBLE SHOOTINg
Cause
On/Off switch is in the
"OFF" (O) position.
GFCI is not plugged in.
Extension cord is too long.
Extension cord is not
proper gauge.
Extension cord is dam-
aged.
Electrical outlet does not
supply adequate power.
Tripped pressure washer
thermal protector.
Diameter of garden hose is
too small.
Water supply is restricted.
Not enough water supply.
Water inlet filter is clogged.
Power nozzle is in low-
pressure position.
Pump is sucking air.
16
Solution
Turn switch to the "ON" ( I
) position.
Plug in GFCI.
Replace extension cord
with either a 25' (7.6 m)
14/3 gauge cord or a 50'
(15 m) 14/3 gauge cord.
Try a different outlet.
Allow to cool, and restart
unit.
Replace with a 1" (25 mm)
or 5/8" (16 mm) garden
hose.
Check garden hose for
kinks, leaks and blockage.
Open water source fully.
Remove filter and rinse in
warm water.
Replace with desired high-
pressure tip.
Check that hoses and fit-
tings are airtight. Turn
"OFF" machine, and purge
pump by squeezing trigger
gun until a steady flow of
water emerges through the
nozzle.