Changing Digital Gauge Format - Craftsman 75114 Operator's Manual

CHANGING DIGITAL TIRE PRESSURE GAUGE FORMAT
The removable Digital Tire Pressure Gauge can be used to monitor air pressure when inflating tires, can
shut off the Inflator automatically to the desired air pressure and can also be used as a separate tire gauge.
SOME VERY IMPORTANT INFORMATION ON THE OPERATION OF YOUR DIGITAL TIRE PRESSURE GAUGE
The Digital Tire Pressure Gauge is capable of reading air pressure in the following formats: PSI, BAR,
2
KG/CM and KPA. The North American standard format is PSI and the gauge is preset at the factory
in the PSI mode. To change the output mode from PSI to one of the other modes:
Press "Reset/On" to switch on the gauge. Wait approximately 2 seconds for the gauge LCD
1.
display to read 0.0.
Hold down "Reset/On" for 3 seconds until the display flashes.
2.
Press "Reset/On" repeatedly to select desired unit of measure: PSI, BAR, KG/CM
3.
4. After selecting the mode, the gauge will reset in the mode selected and will read the output mode in
small letters at the top of the LCD Display. (PSI, BAR, KG/CM
5. When pumping there is approximately 1 to 2 PSI difference between the tire pressure and the
display figure due to the air hose back pressure.
6. The digital gauge display will be subject to fluctuation while pumping.
7. The digital gauge will automatically shut off in 15 seconds when the pressure is under 3 PSI.
8. When the batteries in the Digital Tire Pressure Gauge are getting low, the Low Battery Indicator
will remain on in the upper right hand corner of the LCD Display when the gauge is
functioning. To replace batteries, remove the small Phillips screw in the battery cover on the back
of the gauge. The screw is located above the
with two (2) #LR44 watch style batteries.
Replace all batteries of a set at the same time.
Clean the battery contacts and also those of the device prior to battery installation.
Ensure the batteries are installed correctly with regard to polarity (+ and -).
Remove batteries from equipment which is not to be used for an extended period of time.
Remove used batteries promptly.
Battery Contains Mercury. Do Not Put in Trash. Recycle or Manage as Hazardous Waste.
Do not mix alkaline, standard (Carbon-Zinc), or rechargeable (Nickel Cadmium) batteries
2
or KPA).
indents/markings in the battery cover. Replace
11
2
or KPA.