Table of Contents
Related Manuals for Luxair STD Series
Summary of Contents for Luxair STD Series
- Page 1 I nstructions: All M odels To avoid the risk of accidents or damage to this appliance It is Essential to read these Instructions before it is installed and used for the first time. ©® copyright luxair UK Ltd 2014 Page 1...
-
Page 2: Table Of Contents
Contents: Caring for the enviroment………………………………….03 Warning and Safety………………………………………04-06 Ducting Requirments………………………………………07 Recirculated Hoods………………………………………...08 Checking Your Goods……………………………………..09 Installation of Wall Mounted Hoods STD Models………10-12 Fitting Charcoal Filters…………………………....13-14 Installation of Wall Mounted Hoods CVD Models……. 15-16 ... -
Page 3: Caring For The Enviroment
Caring for the environment Disposal Of the Packaging Disposal of your old appliance Material Electrical and electronic appliances The transport and protective packing often contain materials that, if has been selected from materials, which handled or disposed of incorrectly, are environmentally friendly for could be potentially hazardous to disposal, and can normally be human health and to the environment... -
Page 4: Warning And Safety
This appliance is intended for for the consequences of an inadequate domestic use only. earthing system (e.g. electric shock). Luxair cannot be held liable for Installation, maintenance and repair work may only be carried out damage caused by improper by a suitably qualified and competent... - Page 5 Warning & Safety Instructions When cooking with oil or fat, chip Do not connect the appliance to the mains pans and deep fat fryers etc, do not electricity supply by an extension lead. leave the pans unattended. Never leave Extension leads do not guarantee an open grill unattended when grilling, required safety of the appliance (e.g.
- Page 6 All ducting, pipe work and fittings must be of non-flammable material. These can be obtained from the Luxair web site or from local builders' merchants. Note: All porducts MUST be fitted with a 3amp fuse.
-
Page 7: Ducting Requirments
Ducting kits are used to vent you’ re kitchen odors to the outside of the house, and we recommend that only Luxair ducting kits are used with our products, this will also assure you that the product’s warranty is not affected All Luxair cooker hoods must be fitted with 125mm-150mm ducting. -
Page 8: Recirculated Hoods
Recirculated Hoods Please note that if the hood is not to be vented to an outside wall, the top section of the hood with the vents must be used, this allows the filtered air back into the room. Failure to do so will result in the hood been noisy and will cause it to vibrate;... -
Page 9: Checking Your Goods
1) Unpack the hood and inspect the goods carefully, please check for any cosmetic damage before installation begins, Luxair will not accept liability for cosmetic damage after the hood has been installed, if damage is found then please contact the retailer from where the goods were purchased. -
Page 10: Installation Of Wall Mounted Hoods Std Models
Hoods Check List - Standard 1 Wall Bracket 2 Top Chimney Section with Vents 3 Bottom Chimney Section 4 Reducer 5 Main Body 6 fixing screws Page... - Page 11 Make sure that the fixings are adequate for the type of surface you are fixing to. Luxair provide some screws but they may need changing depending on the type of wall yo u have, if yo u are in an y doubt then seek professio nal advice.
- Page 12 Mark the height and position of your fused spur socket position this so it’s accessible, this should also be fused with a 3amp fuse. Remove the hood off the wall before drilling for the electrics Move the bod y section to the wall and proceed to make all electrical and ducting co nnections, make sure you have complied with all safety...
-
Page 13: Fitting Charcoal Filters
How To Fit Square Charcoal Filters Remove the metal grease filter to reveal the inner flue section. Make sure all wires are pushed to one sid e preventing snagging. Offer the filter to the bottom and back the flue section and insert into back L-shaped bracket. - Page 14 How To Fit Round Charcoal Filters Offer the round filter to the side of the motor housing. Twist Clockwise Slowly until you feel the filter sit. Twist clockwise until you feel it lock Reverse the process to remove Please note that charcoal filters will need replacing every 2 months or every 50 hours of cooking.
-
Page 15: Installation Of Wall Mounted Hoods Cvd Models
Hoods Checklist – Curved Glass/Straight Glass 1. Wall Bracket 2. Top Chimney Section 3. Bottom Chimney Section 4. Reducer Collar 5. Body Section 6. 8mm Safety Glass 7. Fixing Screws Page... - Page 16 Fitting Instructions – All Glass Hoods Follow Fitting Instructions for all wall mounted hoods pages….. Then Continue with this section. After following instructions 1-9 on pages 18-20 continue with this section for the rest of the fitting of this hood. Once the hood is assembled and checked, place your glass directly on top of the main body section, line...
-
Page 17: Operating Instructions
Operating Your Hood 1: Select speed one to activate your fan, then speed 2 and so on. 2: To turn on the lights press the light Electronic Switches switch. 3: The T button is a timer switch, when pressing the T button it will start to flash! This means you have activated the timer unit, your hood will then turn its self off after 20mins, to cancel... -
Page 18: Installation Of All Island Hoods
Installation- all Island hoods Please note: All Luxair Islands are installed in ex actly the s ame manner and it is only the shape and design that differ, please use the following steps for all Island unit models Please note that the installation of all Island hoods should be carried out by at least two people. - Page 19 Before you go any further assemble the glass (applicable to glass units only) over the main body of your hood and secure with screws and washers (provided). Do not over tighten these screws as you may cause the glass to shatter. Insert the top stainless steel chimney section into the bottom stainless steel section;...
- Page 20 When you have selected the correct height above your hob secure the inner bottom section of the flue, to the inner top section of the flue in the fixing positions as opposite. Your cooker hood should now be secure. Make all final ducting and electrical connections through the specially cutout hole.
-
Page 21: Changing The Bulbs
How To Change A Halogen Light Bulb How to change a halogen bulb? Replacing Your Cooker Hood Halogen Bulbs 1. Please make sure that your cooker hood is switched off at the mains before any work is carried out on your extractor. - Page 22 Twist the bulb anticlockwise to remove, replace with a 20/40 w max screw bulb. Bulbs are not covered by warranty and can be purchased from the Luxair Website www.luxairhoods.com Page...
-
Page 23: Changing Your Light Fittings
How To Change A Cooker Hood Light Fitting Replacing your Cooker Hood Light Fitting 1. Remove your Metal grease filters to allow you access to the inside of the hood. 2. Once removed you will be able to push the light fitting out from inside the hood 3. -
Page 24: Problem Solving
Below are a few checkpoints you need to carry out before you call us; unnecessary phone calls can be avoided by checking before you call, Please note that Luxair cannot be held responsible for incorrect installation of the ducting system, any problems relating to this... -
Page 25: Cleaning And Care
Cleaning And Care Before carrying out any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that: – it is switched off at the wall socket and the plug withdrawn, or – the fuse is withdrawn from the fused spur connection unit, or –... - Page 26 Do Not Use: – Cleaning agents containing soda, acids, chlorides or solvents, – Abrasive cleaning agents e.g. powder cleaners or cream cleaners, and abrasive sponges, e.g. pot scourers or sponges which have been previously used with abrasive cleaning agents. These will damage the surface material.
-
Page 27: Technical Specifications
Technical Information: Fan performance wall mounted Total connected load* ..240 W hoods Fan motor*....200 W Hood lighting . -
Page 28: Warranty Form
Once we receive your Warranty registration you will receive a warranty confirmation letter, please keep this safe in the event of a claim, If you do not receive this after 14 days of registering please contact Luxair. Warranty’s can also be registered online at WWW.LUXAIRHOODS.COM... -
Page 29: Terms And Conditions
3amp fuse. Luxair Terms & Conditions Luxair cooker hoods operate a policy of continuous improvement and reserves the right to adjust and modify its products and prices without prior notification. All the Operational Extra Kits can be purchased if required. - Page 30 If you do not receive confirmation within 14 days of registering please advise Luxair immediately. It is advised if registering via post to send recorded delivery in the event that we do not have your registration on record in which proof of postage will be accepted. If sent via standard delivery Luxair cannot be held responsible for any warranties lost in transit, it is your responsibility to ensure your warranty form has been registered or alternatively register online.
-
Page 31: Terms And Conditions
Once a delivery date has been agreed with yourself you must be in to accept delivery or advise Luxair of an alternative delivery address 24 hours prior agreed delivery date. Any redelivery of goods will be subject to an additional delivery charge and will delivered at the next available date. -
Page 32: Contact Us
Lux Air UK, Lux Air House, Unit 2 & 5, Keld Close Barker Business Park, Mel merby, Ripon North Yorkshire HG4 5NB Telephone: OO44 (0) 1765 641888 0044 (0)1765 641889 Help Line 0044 (0) 1765 641888 Email:info@luxairhoods.com Web: www.l uxairhoods.com Alteration rights reserved / 1306 M.-Nr.
Need help?
Do you have a question about the STD Series and is the answer not in the manual?
Questions and answers