Gps Troubleshooting; Gps Settings For Phoenix; Gps Control; Gps Quick Test Window - Nokia RM-632 Service Manual

GPS troubleshooting

GPS settings for Phoenix

GPS control

Context
Use the following to test GPS using Phoenix.
Steps
1. Start Phoenix service software.
2. From the File menu, select Scan Product and check that the correct product version is displayed.
3. From the Testing menu, select GPS Control. This opens up
figure below, and enables the GPS.
Select Receiver On to confirm the GPS is enabled and is in idle mode; at this point all clocks should be
present, GPS_En_Reset & SleepX should be high, and Vdd_Dig, Vcc_TCXO & Vcc_PLL/VCO will be present.
Receiver On turns on all RF sections of the ASIC and so all LDOs will be on. These checks are part of
basic checks troubleshooting (page 3– 0

GPS Quick Test window

GPS Quick Test window has all the necessary functionality for GPS troubleshooting. Ensure the test setup
The
is correct and click Start Test. (Select Help for further information).
Page 3 – 34
Figure 11 GPS Control dialog box
) .
COMPANY CONFIDENTIAL
Copyright © 2010 Nokia. All rights reserved.
RM-632; RM-634; RM-699
BB Troubleshooting and Manual Tuning Guide
GPS Control dialogue box, as shown in the
GPS
Issue 3