Wcdma Rssi Measurement - Nokia RM-632 Service Manual

Figure 44 Phoenix Rx Control window with sample settings (WCDMA band I)
2. Make settings for the band to be tested according to the following table:
Band to be tested
WCDMA I
WCDMA II
WCDMA V
3. Make the following general settings (the same values for all bands):
Setting
AGC Mode
AFC Algorithm
AFC DAC
4. Click Start to activate the settings.
If the settings are changed later on (for example, change of channel) you have to click Stop and Start
again.
Note: Clicking Stop also disables TX control if it was active.

WCDMA RSSI measurement

Prerequisites
WCDMA RX must be activated before RSSI can be measured. For instructions, please refer to
activation for manual measurement (page 6–11 )
Page 6 – 8
Phoenix Channel
10700
9800
4400
Algorithm
OFF
1024
.
COMPANY CONFIDENTIAL
Copyright © 2010 Nokia. All rights reserved.
Service information differences between RM-632 and
Signal generator to antenna
2141.0MHz
1961.0MHz
881.0MHz
Value
RM-632; RM-634; RM-699
RM-634
connector
WCDMA RX chain
Issue 3