Table of Contents
Advertisement
Position
WARNING: To prevent personal injury or damage to the
equipment, take the following precautions when installing the
equipment:
•
The UPS must be installed at the bottom of the rack. If
placed in the rack with existing equipment, the rack must be
reconfigured to allow installation of the UPS at the bottom of
the rack.
•
The UPS must be mounted on the rails included in the UPS
kit. Use the rack template tool included in the kit to align the
rails.
Checking the Battery
Recharge Date
Before unpacking the UPS, check the battery recharge date
specified on the battery recharge date label that is affixed to the
shipping carton.
IMPORTANT: Do not use the battery if the recharge date has passed. If the
date on the battery recharge date label has passed without the battery being
recharged, contact an HP authorized service representative for directions.
NOTE: The following label is only an example date. The date on your carton
may be different.
THIS PRODUCT CONTAINS
A NONSPILLABLE BATTERY
Next Recharge Date:
14-DEC-04
Please refer to Maintenance Section
of Owner's Manual enclosed inside
Kit Contents
Documentation
• International Regulatory Compliance guide
• Important Safety Information guide
• Power Products Documentation CD
• Rack and Power Management Pack CD
• This document
Rails
• Rails, with mounting hardware
• Rack template tool 2U (295523-023)
UPS
• UPS chassis
• Front bezel
• Rear stabilization brackets (2)
• Remote Emergency Power Off (REPO) port and
connector block
• Battery pack (1)
Additional Hardware
The following items are supplied for shipping a rack with a
UPS installed:
• M6 nuts (4)
• M6 flat washers (4)
• M6 split washers (4)
Cables
• The R1500 XR NA model ships with a non-detachable input
power cord with a NEMA 5-15 plug and a 3.66-meter (12-foot)
UPS/computer interface cable (201092-002).
• The R1500 XR JPN model ships with a non-detachable input
power cord with a NEMA 5-20 plug and a 3.66-meter (12-foot)
UPS/computer interface cable (201092-002).
• The R1500 XR H INT'L model ships with:
Two 10 A, 2.44-meter (8-foot) IEC-to-IEC power cords
(142263-002)
Two 10 A, 3.05-meter (10-foot) IEC-to-IEC power cords
(142263-003), for load equipment power
A 3.66-meter (12-foot) UPS/computer interface cable
(201092-002)
Use the jumper cord supplied with the UPS to attach your
equipment to the output of the UPS. Use the equipment power cord
to attach the UPS to utility power using the IEC-320-C14 inlet on
the rear of the unit.
NOTE: All models ship with a computer interface cable. The computer
interface cable is not needed for normal operation. To administer the UPS
with power management software, connect the interface cable between the
UPS communications port and the serial port on the host computer.
Tools and Materials Required
The following tools are required:
• #2 Phillips screwdriver
The following items are supplied with the rack:
• Screws
• Cage nuts
• Cage nut-fitting tool
Advertisement
Table of Contents
