Manual Geometry Alignment - Mitsubishi Electric WD-60C10 Service Manual

MODELS: WD-60C10 / WD-65C10 / WD-73C10 / WD-60638 / WD-60638CA / WD-65638 / WD-65638CA /
WD-73638 / WD-60738 / WD-65738 / WD-73738 / WD-82738 / WD-65838 / WD-73838 / WD-82838

Manual Geometry Alignment

V43C & V43
1. Entering the Manual Geometry Alignment Mode
1. Activate the Service Menu <MENU><2-4-7-0>.
2. Select "Calibration" <ENTER>. A "dot pattern" will be displayed.
3. Enter the Manual Geometry Alignment mode by pressing <1-3-9-7>. The Manual Geometry Alignment Pattern
will appear and the STATUS LED will slowly blink Green during the alignment. See 2. Manual Geometry
Alignment procedure on the next page.
Manual Geometry Alignment
V43+ & V43++
1. Entering the Manual Geometry Alignment Mode
1. Activate the Service Mode <MENU><2-4-5-7>.
2. From the Service Menu, press the <0> button. The Data Transfer & Geometry Menu will appear.
Data Transfer & Geometry Menu <MENU><2-4-5-7><0>
RESTORE ENGINE DATA FROM BACKUP
RESTORE GEOMETRY DATA FROM BACKUP
MANUAL GEOMETRY ALIGNMENT
RESTORE INDEX DELAY
SAVE ENGINE AND GEOMETRY SETTING TO BACKUP
BACKUP AND RESTORE ISF SETTINGS
RED ONLY AND GREEN ONLY
3. Use the <> buttons to select "MANUAL GEOMETRY ALIGNMENT" <ENTER>. The Manual Geometry
Alignment Pattern will appear. See 2. Manual Geometry Alignment procedure on next page.
V43C & V43 Option / Service Menu
<MENU><2-4-7-0>
Service Menu
1. Information
2. Reset All Settings
3. Calibration
4. Test Pictures
Page 37