Samsung MIM-H03UN User & Installation Manual page 8

4 . Reassemble the Wi-Fi kit .
• Put the front cover of the kit into the upper grooves first and then fit it as shown in the picture . After
assembling the Wi-Fi kit, please check if there is any gap because of the connection cable between front
NOTE
cover and rear cover .
• When installing a Wi-Fi kit with 10 m (32 . 8 feet) or more wire, the communication wire and power wire of a Wi-Fi kit
should be installed separately . (The Wi-Fi kit will malfunction because of electrical fault . )
CAUTION
• When installing a Wi-Fi kit on the wall, select proper thickness of wires in the consideration of the hole size for wire
on the wall .
• Wire for Wi-Fi kit PCB connection
- When installing a Wi-Fi kit in a buried way, install the kit in accordance with U-terminal wiring Specification .
- When installing a Wi-Fi kit with 4-line PVC wires, peel 30 cm (0 . 9 8 feet) of the sheath for the PVC wire and use only
4-line wires . (Recommnendation: AWG22)
• Specification of compressed U-terminal for connecting Wi-Fi kit PCB
The maximum wiring length for communication and power : 50 m (164 feet)
• Tighten the fixing screws to the PCB terminal with less than 6Nm torque . When the screws are tightened with more
than 6Nm torque, the screw thread will be damaged .
5 . Start the Wi-Fi kit .
f When the Wi-Fi kit is turned on, all the lamps are turned on until system operates . f
f After the system operates, tracking is performed automatically . f
6 . Perform the tracking .
❋ ❋ Tracking : You can search the devices connected to the Wi-Fi kit with the tracking function . The devices connected to Wi-
Fi kit recognize that they are connected to the Wi-Fi kit . To monitor or control the system air conditioner with
Wi-Fi kit, tracking should be performed .
f When the Wi-Fi kit is turned on, the tracking is performed automatically . During the tracking, the lamp of f
the Wi-Fi kit ( ) (
f If the tracking is completed but the lamp ( f
this case, check whether the connection of communication cable between indoor unit and outdoor unit is correct or is
affected by noise .
f If the configuration of indoor unit or outdoor unit is changed, tracking should be performed again manually by pressing f
the button (SW3) inside the Wi-Fi kit . (Ⓑ-
• Set the OnOff controller of indoor units to 'Use' in the option setting to control indoor units through the Wi-Fi kit . If
the OnOff controller is set to 'Disuse' , the indoor units cannot be controlled with the Wi-Fi kit .
CAUTION
• When the tracking is completed correctly, the process which connects the wired/wireless router to the Wi-Fi kit is
required to control indoor units by a mobile phone . For this process, refer to the 'Starting Samsung Smart Home
NOTE
App' in Page 11 .
• When the tracking is completed correctly, the lamp (
wireless router to Wi-Fi kit is completed .
CAC Wifi APP-NA_IBIIM_EN_DB68-05417A-00.indd 7
Wire range for
E
connection
W Stud D
AWG
F G
L
22~16
t
) blinks .
) blinks, it means the Wi-Fi kit does not find connected indoor units . In
)
Rated Stud
size size
mm mm mm t ΦD
2 2
0 . 2 5~
1 . 5 3 0 . 7 3 . 8 10 . 0 4 . 5
1 . 6 5
) is turned on until the process which connects the wired/
Basic size(mm)
G E F W L
6 . 5 6 . 0 21 . 2
7
2015-03-16 오후 2:21:46