Power Cord - Sanyo abc-vw24 Service Manual

Replacement Procedure
(3) Replacing Control Circuit C (Switch)
1, Remove the upper case and switch cover.
2, Remove the 3 Control circuit C (switch)
setscrews and remove Control circuit C
(switch).
Control circuit C (switch) setscrews
(4) Replacing Control Circuit A (Power)
1, Remove the 2 unit case setscrews and
remove the unit case.
Transformer
Transformer
setscrews

Power cord

2, Remove all of the connectors connected
to Control circuit A (power).
3, Remove the 3 Control circuit A (power)
setscrews and remove Control circuit
A (power).
Control circuit A (power) setscrews
Control circuit A (power )
Photo - 6
Switch cover
Back cover Photo - 6
Photo - 7
Unit case
Unit case setscrews
Holder setscrew
Holder
Photo - 7
Photo – 8
Photo - 8
Photo - 8
(5) Replacing the Transformer and
Power Cord
1, Remove the holder (power cord)
setscrew and remove the Power cord.
2, Remove the 2 transformer setscrews
and remove the transformer. Photo – 7
(6) Replacing the Micro Switch
1, Remove the switch holder setscrew.
2, Remove the soldering of the lead wire
of the micro switch terminal and remove
the micro switch.
Switch holder
setscrew
(7) Replacing the Control Circuit
(Ultrasonic Unit Drive)
1, Remove the inset of the air guide A nail
and remove the shield case from air
guide A.
2, Remove the 2 Control circuit (ultrasonic
unit drive) setscrews.
3, Remove the soldering of the lead wire of
the Control circuit (ultrasonic unit drive)
terminal and remove the Control circuit
(ultrasonic unit drive).
Control circuit (ultrasonic unit
drive) setscrews
Control circuit (ultrasonic unit drive)
- 17-
ABC-VW24
Photo – 7
Photo – 9
Photo - 9
Micro switch
Photo - 9
Photo – 10
Photo – 10
Photo - 10
Shield case
Air guide A
Photo - 10