Installation Floor Requirements; Printer Location Space Requirements - HP Designjet 8000s Series Installation Manual

Installation Site Check

Installation Floor Requirements

The Floor Must be Level
The floor must be level to distribute the load evenly over the leveling feet and
to keep the printer horizontal.
Levelness: Within two degrees on both the long and short sides on the
bottom of the printer (visual check).
The pallet in which the printer sits has castors, so there must be no
obstructions on the floor which could obstruct the path of the printer when
moving to the installation site.
The Floor Must be Strong Enough
The floor must have sufficient strength so that it can hold the weight of the printer.
The strength of the floor that must support the four castors is shown below:

Printer Location Space Requirements

There must be sufficient space around the printer for the replacement of
consumables, for the printing of drawings and graphics, and for ventilation.
In addition, installation/maintenance space is required, which is shown
below, to repair the printer or replace service parts.
Also, the minimum height requirement is 5.6 feet (1.7 meters).
The space mentioned is applicable only to the printer. More space will be
required if the HP Dryer, HP Air Purifier System and PC are installed.
2-4
Printer weight: 211 kg (468 lb) (including consumables).
Load on each castor: 54 kg (1 19 lb) or less.
A = 1 meter (3.3 feet).
B = 0.6 meter (2 feet).
HP Designjet 8000s Series Printer Installation Guide