JVC vn-t216vpru Quick Manual page 9

To prevent the camera from falling off, ensure that it is connected to a firm place
(ceiling slab or channel) using a Safety Wire (Fall Prevention Wire is not
supplied).
Warning
Pay also careful attention to the length, strength, wiring, and material (insulating
properties) of the fall prevention wire to be used. The length should be as short
as possible within the permissible range of the mounting length. The wire
should be strong enough to withstand the total weight of this product. (Pay also
attention to the finishing at the end of the wire.)
Must be isolated camera and the wall/ceiling which are connected by the Safety
Caution
Wire (Fall Prevention Wire).

4S Electrical junction box(Optional)
1. Secure the mounting kit (optional) to 4S Electrical box using 2 appropriate
screws.
2. Then secure the camera case to mounting kit using 2 appropriate screws.
3. Tuck the cables in the 4S Electrical box.
4. Adjust the view angle (zoom, focus, and Horizontal Rotation).
5. Attach the camera housing.
6. Turn the power on after you have installed the camera.
8
This mounting kit
is optional
accessory.