Drive Belt Removal Installation - BOMBARDIER citation ls Operator's Manual

Belt Guard Removal
•
WARNING: Belt guard should
always be in place when engine
is running.
A.
Raise the hood and pull both retain-
ing pins out.
B. Pull the guard out of the center re-
taining bolt.
C. Remove the guard.
1
0
Pull hair pin
I
3 0 Raise driven pulley
support.
4. Slip the belt over the top edge of the
sliding half.
Driven pulley 1
0
Twist clockwise
2° Push
3. Open the driven pulley by twisting
and pushing the sliding half. Hold in
fully open position.
Drive Belt Removal
Installation
1. Remove the belt guard.
2. Unlock and raise driven pulley
support.
_ _ _ _ _ _ _ _ _ _ _ _ _ 21