DeWalt DW615 Manual page 21

18 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance. Follow the
instructions for maintenance and changing
accessories. Inspect the tool cords at regular
intervals and, if damaged, have them repaired by
an authorized D WALT repair agent. Inspect the
E
extension cords periodically and replace them if
damaged. Keep all controls dry, clean and free
from oil and grease.
19 Check for damaged parts
Before using the tool, carefully check it for
damage to ensure that it will operate properly
and perform its intended function. Check for
misalignment and seizure of moving parts,
breakage of parts and any other conditions that
may affect its operation. Have damaged guards
or other defective parts repaired or replaced as
instructed. Do not use the tool if the switch is
defective. Have the switch replaced by an
authorized D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Additional safety rules for cutters
• Always use cutters with a shank diameter
corresponding to the size of the collet installed in
your tool.
• Always use cutters suitable for a speed of
-1
30.000 min and marked accordingly.
• Never use cutters with a diameter exceeding the
maximum diameter indicated in the technical
data.
Package contents
The package contains:
1 Router
1 Parallel fence with guide rods
1 Collet 8 mm (GB: 1/4")
1 Wrench # 13/17
1 Guide bush 17 mm ø
1 Dust extraction channel
1 Instruction manual
1 Exploded drawing
16
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your D WALT high performance router DW614/
E
DW615 has been designed for professional heavy duty
routing applications in wood and wood products.
1 On/off-switch
2 Routing depth graduation
3 Depth stop
4 Plunge limiter
5 Depth stop locking bolt
6 Revolver depth stop
7 Spindle lock
8 Collet nut
9 Dust extraction channel
10 Parallel fence locking bolt
11 Router base
12 Speed control dial (DW615)
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
E N G L I S H
en - 3