Table of Contents
Advertisement
6.3. Clearing the self-diagnostic function
The contents of abnormality display are stored in memory. In order to clear the memory, continue to press the
STOP button (
Always be sure to clear this memory after completing repair.
7. Self Check Function
This unit is equipped with a self check function which can detect a part of malfunction. Use this self check
function before servicing the unit and check the item as shown below.
7.1. Setting to the self check function
1. Turn the power ON.
2. With no MD loaded in the unit, press and hold the STOP button (
pressing the STOP button (
seconds. Then the unit is set to the self check function, the FL display is turned off. Refer to
7.2. Checking the operation buttons
When the unit is set to self check function, press the operation buttons on the unit except the POWER button
(POWER). It displayed "-" mark adapted each buttons. Refer to
) for at least 5 seconds while in the self-diagnostic function. The memory will clear.
), press the R. SEARCH button (
) for at least 2 seconds. And then while still
Fig. 7-1.
Fig. 7-2.
and
Fig. 7-2.
Fig. 7-3.
8
) for at least 2
Fig. 7-1.
Fig. 7-3.
about allotment.
Advertisement
Table of Contents
