Assembly; Cartridge Filter - Sealey pc310 Instructions For Use Manual

Valeting machine wet & dry
Hide thumbs Also See for pc310:
Table of Contents

Advertisement

5. ASSEMBLY

DO NOT connect to the electricity supply before completing this process. .
5.1.
5.2.
See 4.1.1.
5.3.
See 4.1.1.
5.4.
See 4.1.2.
5.5.
Insert a large wheel on each side of the rear basket and ensure they are pushed all the way in.
5.6.
Turn the tank upside down and insert the moulded castor mountings into their positions in the black base. Retain each
castor moulding with the self tapping screws provided.
5.7.
For dry suction fit the cartridge filter.
5.8.
For carpet washing or wet suction fit the foam filter.
5.9.
Re-assemble the top to the tank.
5.10. Fasten the 2 clasps.
5.11.
Attach the suction hose to the suction inlet on the front of the tank.
5.12. Push the end of the suction hose into the air diffuser handle. See fig.1 item 23. Push the end of the air diffuser handle into the
telescopic extension tube. Fit the required accessory to the base of the extension tube or directly to the diffuser handle if the
extension tube is not required.

6. CARTRIDGE FILTER

WARNING! Always disconnect the plug from the mains supply before removing the tank cover.
R
6.1.
IMPORTANT: The filter is made of high quality paper designed to filter small particles of dust. We Recommend that this filter be
used to dry vacuum only.
6.2.
The filter must be completely dry when used to collect dry dust only. A wet or damp filter will clog quickly and be very difficult to
clean.
6.3.
Check the filter carefully and regularly for tears or small holes. Even a small hole can cause dust to be exhausted. Never use a
filter with holes or tears as this may cause damage to the motor and invalidate warranty. Replace it immediately.
Installing & Cleaning
6.4.
Slide cartridge filter down over filter cage.
6.5.
Hold the base rim of the filter and gently push and twist it until the top rim fits snug against the lid assembly. Ensure there is
no gap between filter and lid assembly.
6.6.
To remove filter for cleaning, hold the base of the filter and pull it off the cage gently.
6.7.
Clean dry filter by tapping it on the inside of a waste can.
© Jack Sealey Limited
Original Language Version
PC310 Issue:7(S) - 27/05/15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents