Bleeding The Rear Brake - Beta X-Trainer 300 2T User Manual

4
WARNING:
The brake fl uid is extremely corrosive. Take care not to spill it on the paintwork.
WARNING:
Wear appropriate protective clothing and protection gloves.
Avoid any direct contact of the liquid with skin, eyes or clothing. If this happens:
- with the eyes, rinse immediately with plenty of water and seek medical advice.
- with skin, immediately clean contaminated areas with soap and water. Change
clothing that is contaminated with liquid.
If liquid is swallowed, contact a doctor immediately.
Keep liquid out of reach of children.
GB
2
1

BLEEDING THE REAR BRAKE

To bleed air from the rear brake circuit,
proceed as follows:
•Remove the rubber cap 1 from the valve 2.
•Open the sump cap.
•Place one end of a small transparent tube
into the valve 2, and the other end inside
a container.
•Pump with the brake lever 2/3 times and
keep the pedal pressed.
•Unscrew the valve and let the oil drain.
•If are still visible in the tube repeat above
operation until obtaining a continuous
outfl ow of oil within no air bubbles.
•Close the valve and release the lever.
NOTE:
During this procedure, continuously top up
the brake pump thank to replace the oil that
is out fl owing.
•Remove the tube.
•Replace the rubber cap.
•Close the oil reservoir cap.
Use the liquid indicated on page 16 in
the "Recommended lubricants and liquids"
table.
52