Delete Mode; Loading Code-Libraries - NAD HTR-3 Owner's Manual

DELETE MODE

The HTR 3 can store learned, copied, and "default library"
commands on any single key (The default library commands
are the pre-programmed NAD codes, such as the native NAD
receiver commands on the [AMP] "page. " ).
You can delete commands by layers back "down" to the default
library command on any key, removing learned commands,
punched-through functions, and copied keys.
NOTE
To enter Delete Mode, simultaneously press-and-hold for 3
seconds both the desired key's DEVICE SELECTOR key and the
[RTN] key, until the Learn LED turns green. Press the function
key whose command you wish to delete; the Learn LED
flashes; the number of times indicates which type of function
has become active - see the table below. Press the active
DEVICE SELECTOR key again to exit Delete Mode.
NOTE

LOADING CODE-LIBRARIES

The HTR 3 can store a different library of default NAD codes
for each of its DEVICE SELECTOR "pages. " If the original default
library does not control your NAD CD player, DVD player or
other component, follow the procedure below to change the
code-library.
Begin by ensuring that the component you wish the HTR 3
to control is plugged in and powered-up ("ON, " not merely in
standby). To enter the HTR 3's Library Mode, simultaneously
press-and-hold for 3 seconds both the desired DEVICE SELECTOR
key and the [AVPS] key, until the Learn LED turns green.
While keeping the HTR 3 pointed toward the component,
enter the first appropriate three-digit code-library number
from the table below and then press [OFF]. If the component
turns off, press [ENTER] to accept that code-library number
and exit the Library Mode. If the component does not turn off,
enter the next three-digit code-library number from the table.
R3_eng_OM_v02.indd 7
The default library commands cannot be deleted, so
you need not worry that using Delete Mode might cause
irreparable changes.
You may delete multiple function-key commands on the
same DEVICE SELECTOR "page, " but to delete from more
than one DEVICE SELECTOR page you must exit Delete
Mode and then re-enter it on the required page.
Flashes Command Type
1 Default Library Command
2 Copied Library Command
3 Learned Command

7/8/07 22:03:27