DeWalt de7400 Instruction Manual page 19

Attaching the Rubber Bumpers
(fi g. 6)
Attach the two rubber bumpers (m) to the handle
side leg support as shown using the screws and
lock nuts provided.
Table Saw Bracket Mounting
(fi g. 7–10)
WARNING: To reduce the risk of
injury, turn unit off, disconnect
machine from power source before
assembling the table saw to the
table saw stand. An accidental start-
up can cause injury.
WARNING: For your own safety,
read and understand the table saw
instruction manual before using. Failure
to heed these warnings may result in
personal injury and serious damage to
the table saw and the accessory.
WARNING: The saw mounting brackets
provided with this stand are equipped
with lever locks. To reduce the risk of
injury, DO NOT modify the mounting
bracket lever locks.
1. Unfold the legs (h) by depressing the leg release
levers (f). Rotate the legs until the locking pin (g)
clicks into its detent (r).
2. Turn the stand upright. The stand should be
stable and should not rock.
WARNING: Be sure that the locking
pins have engaged and the legs are
firmly held in place.
IMPORTANT: The mounting brackets MUST be
attached with the arrows facing the front of the
stand as shown in figure 1B.
3. The locator clip (j) keeps the saw from sliding
left or right during cutting operations and during
transport. Install the mounting brackets on to
the beam as shown by engaging the concave
front lip of the mounting bracket with the
rounded front edge of the beam. One of the
brackets must engage the locator clip (j). The
mounting bracket release levers (e) must be
positioned to the rear of the stand as shown.
4. Measure the distance between the mounting
holes of the table saw. Position the second
mounting bracket onto the beam at this
distance from the first mounting bracket.
5. Align the holes in the table saw base with the
slots in the saw mounting brackets (d).
6. Feed a hex head bolt with flat washer installed
through each of the four holes in the table saw
base and mounting brackets. Secure each
location with a flat washer, lock washer and nut
provided.
WARNING: To reduce the risk of
personal injury, be sure the table saw is
fully anchored on the stand.
WARNING: The table saw must
be positioned on the tool mount so
that all four corners can be bolted
to the mounting brackets. If the saw
is mounted properly, the mounting
brackets will be positioned perpendicular
to the stand rail when the saw is placed
on the stand.
For additional questions or clarification on the above
instructions, consult an authorised D
agent.
To Detach the Saw from the Stand
(fi g. 11, 12)
WARNING: To reduce the risk of
injury, turn unit off, disconnect
machine from power source before
detaching the table saw from the
table saw stand. An accidental start-
up can cause injury.
The saw mounting brackets included with the
DE7400 stand are equipped with rubber feet that
can support the saw when cutting on a work area
without a stand.
TO REMOVE THE SAW FOR CARRYING OR FOR USE
WITHOUT THE STAND
1. Reach around the sides of the saw and grasp
the release levers (e).
2. Pull up slightly to clear the beam and tilt the saw
toward you to carry.
TO REATTACH THE SAW AND SAW MOUNTING BRACKETS
TO THE STAND
1. Grip the table saw table as shown while facing
the front of the saw.
2. Position the left-hand side mounting bracket
into the locator clip.
3. When the front concave lip of both mounting
brackets are engaged with the front round edge
of the beam, pivot the saw back and down
allowing the release levers (e) to click into place
on the rear beam. Rock the saw gently to verify
the mounting brackets are locked onto the
beams.
EN GL IS H
WALT repair
E
17