Spa Control Panel Operations For The Sx & Tx Spas Only; Temperature Control - HotSpring HOT SPOT Tempo Owner's Manual

TO ADJUST BALANCE
From the SETUP screen:
Press the (+) b utton to display one of four audio sources, IPOD,TV, AUX, BLUE.
1.
2. Press the MODE () button to display TRE.
3. Press the MODE () button to display BAS.
4. Press the MODE () button to display BAL -5 to +5.
5. Press (+) b utton to raise the Balance # or press (-) b utton to lower the Balance #.
TO ADJUST SUBWOOFER
From the SETUP screen:
Press the (+) b utton to display one of four audio sources, IPOD,TV, AUX, BLUE.
1.
2. Press the MODE () button to display TRE.
3. Press the MODE () button to display BAS.
4. Press the MODE () button to display BAL.
5. Press the MODE () button to display SUB 0 to 11.
6. Press (+) b utton to raise the subwoofer # or press (-) b utton to lower the subwoofer #.
TO CHANGE AMPLIFIER CHANNEL
HOUSE IF INSTALLED)
From the SETUP screen:
1. Press the (+) b utton to display one of four audio sources, IPOD,TV, AUX, BLUE.
2. Press the MODE () button to display TRE.
3. Press the MODE () button to display BAS.
4. Press the MODE () button to display BAL.
5. Press the MODE () button to display SUB.
6. Press the MODE () button to display CHAN 1-5.
7. Press (+) b utton to raise the channel # or press (-) b utton to lower the channel #.
NOTE: Channel number must match Transmitter number inside house to work properly
SPA CONTROL PANEL- SX & TX MODELS ONLY
Your control panel consists of an LED display and convenient touch
pads that allow you to set the water temperature and adjust the skim/
filter cycle settings, lock spa temp, lock entire spa functions, as well as
control the hydrotherapy jets, and lights from spa-side.
LED DISPLAY
The LED display on your spa-side control panel continually shows the
spa's actual water temperature. In certain situations, it will also display
other messages. See TROUBLESHOOTING section.
SET BUTTON
Use the set button to control clean cycle, filter cycle, locking and light
functions. To activate the desired mode, press the SET button. When
the "SET" icon flashes push the applicable button. The SET mode READY
SET
ends after 3 seconds or when the"SET" icon stops flashing.
F1
F2

TEMPERATURE CONTROL

The set temperature range is from 80°F
READY
(26°C) to 104°F (40°C). Temperatures
of any setting may rise slightly depending on the current use and condition of your spa, and on outside temperature.
Whenever power is disconnected and then reconnected to the spa, the water temperature setting will automatically
return to the last temperature entered into the program.
READY
(TO MATCH WIRELESS DOCK TRANSMITTER INSIDE
Temperature Up
READY
SET Temperature Down
F1
F2
READY
READY
Page 22
F1 Page 22
POWER
POWER
POWER
POWER
POWER
POWER
Filter Cycle 1
Icon
Set Icon
POWER
Jets Button
POWER
POWER
READY
Filter Cycle
Light Button
Set Button
2 Icon
READY
READY
Operating Instructions
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
Temp / Lock
Display
Sleep
POWER
Temp
Icon
Ready
Icon
POWER
POWER
Filter Cycle Icon
Jet Icon
Light Icon
POW
POW
POW
POW
POW